![]() ![]() Be sure to save your BIOS changes and exit to reboot your computer. If you see "UEFI Boot", switch the option from "Enabled" to "Disabled". In the case of "UEFI/BIOS Boot Mode" switch the mode from "UEFI" to "Legacy" mode. Once in your system BIOS, look under the Boot menu to find an option that reads "UEFI/BIOS Boot Mode" or "UEFI Boot". If you are not sure, consult the User Guide that came with your computer or call the manufacturer's technical support for assistance. Depending on the manufacturer of your system, you can press the DEL key, the F2 key or another key that is listed on screen to access the system BIOS. Here is how you can check your BIOS settings.Īt the moment of turning on your computer, you will see an option to enter SETUP. You will need to check your system BIOS settings to ensure your system is set to Legacy mode or that UEFI is disabled. ![]() This issue may be related to the BIOS mode that is set on your computer. It either sits at a blank screen or just tries to boot up from my hard drive. Once the installation menu appears, select the Shift + F10 keys to open a new command prompt window.Technical Questions Disk Image The Boot Disk bootable media is not booting up my system after I've selected the correct Boot Priority. To begin, insert your installation media and start your PC and change your boot order (using the steps above) to load the Windows installer.If you want to proceed, you’ll need Windows installation media on a USB drive or DVD first to be able to run this command on a drive that no longer boots. If you’re unsure what you’re doing, you’ll need to use another method to back up your drive first. This carries extreme risk, however, and could cause you to lose all saved data on a drive. If you’ve switched from MBR to GPT recently, you may have corrupted your bootloader.Īs a PC’s BIOS/UEFI requires this information to boot Windows, you’ll need to repair or replace it first using the diskpart command. Older Windows installations used a Master Boot Record (MBR) to save hard drive partition information to your drive, giving your PC information on where to find and load Windows system files. Repair Windows Bootloader (GPT or MBR) Using Diskpart Once the Windows installation screen appears, select the Shift + F10 keys to open a command prompt window. You may need to change the boot order (using the steps above) to ensure your USB or DVD media is selected first. To start, insert your Windows installation media and start up your PC.Otherwise, this step won’t work, and you’ll need to try another method. ![]() However, this will only work if your drive is detected by your PC in your BIOS/UEFI menu and by the Windows installation media. This will give you access to a command prompt in the Windows installation menu, allowing you to run the SFC command to scan for corrupt files on your drive. You can check for corrupt system files using the System File Checker (SFC) tool.Īs Windows can’t boot, however, you’ll need to create a Windows 10 installation USB stick (or DVD) first. If your hard drive is connected properly, it could point to a corrupt Windows installation. Always replace damaged cabling when you spot it to prevent your drive from being damaged. A frayed or exposed cable may also stop your drive from working. Before you close your case, however, you should also check for damage. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |